Модераторы: Typhoon, Komiss, Лютег, Mur
Programme the end of travel for the window opening control unit following the instructions given below.
Get inside the vehicle and close the door.
Turn the ignition ON and, using the switch for the electric window involved, place the window in the ''fully lowered'' position and keep the switch pressed for 10 seconds.
Still using the switch, place the window in the ''fully raised'' position and keep the same switch pressed for 10 seconds.
The window offset for the up and down function is programmed in the control unit starting from the ''fully raised'' position memorized previously.
The procedure described above for programming the electric window control unit end of travel, should be carried out each time the battery leads are disconnected.
acab писал(а): Но если при открытой двери, и опущенном стекле - закрыть дверь - то стекло само поднимается до конца. В принципе - очень удобно.
Иван13 писал(а):Нет это не сигналка,это штатная система.
acab писал(а):признавайтесь, кто настраивал стёкла, а именно механизм их?
там гдет есть регулировка по осям x,y,z . Тока я ничерта понять не могу.
Сейчас этот форум просматривают: нет зарегистрированных пользователей